DroneBridge for ESP32
If you want to learn more about the project please visit the project home on Githhub and the official website. Make sure to check the docs in the Wiki! DroneBridge for ESP32 is a short-range (<10km) digital telemetry/data link…
Category Software
Countering Drones with Drones – CUAS using cUAVs
This article is work in progress. Introduction In 2013, when DJI launched its first drone, the “Phantom 1”, many people from the general public, for the first time, were able to see an actual drone in real life and up…
Real3DFFF – A 3D printing post-processor to enable curved layer 3D printing
Real3DFFF processes regular 3d printing G-Code. It transforms the plane layers into curved layers that perfectly follow the part’s top & bottom surfaces. Also within the part, the layers are curved. This class of algorithm is also known as Curved…
RepPanel HWv2
visit I created RepPanel as a little side project because available 3D printer UIs were a bit expensive and lacked a proper user experience. The first generation of RepPanel is based on custom DIY PCBs and screens from China.…
RepPanel – A PanelDue Alternative
RepPanel is an open-source embedded user interface for Duet based 3D printers. This article features a quick introduction to the software and then goes into detail on my hardware setup.
DroneBridge
Creating a long range/low latency/ low-cost digital radio link for UAVs & aerial photography As my „not just another drone“ project grew very large over the last year I decided to split it up into different articles. This article focuses…
Not Just Another Drone Project
Introduction So what is this all about?It is about building a complete Quadcopter/Drone from scratch that can be used for filming and aerial photography. Project status (01.04.2023) Code: Project goals Small package for ease of transport. What is a…